|
|
Seller assumes all responsibility for this listing.
Manual hollow chisel mortiser with foot feed. 2hp. 220 volt 3 phase direct drive motor with Jacobs chuck. Compound table with table stops, custom stock clamp, 45 degree tilt to right and left, no gage bar or spring stops. All slides have been cleaned, lubricated, and adjusted and are snug and smooth. Table elevating screw has been cleaned and lubricated. Allan-Bradley manual push-button starter. Only known repair is a weld on the foot feed pedal by a previous owner which appears sound and well done (see photos). Includes three sets of import chisels and bits for 3/4", 5/8", 1/4", and chuck key. Machine is ready to run. I can load on truck or trailer. |
|
|
Seller assumes all responsibility for this listing.
|
Seller assumes all responsibility for this listing.
|
|
|