|
|
Seller assumes all responsibility for this listing.
I've got an early 1900's Baxter D. Whitney $ Son table saw that I'd like to sell. Full working order, many blades, even a 14" dado blade set. Biesemeyer 50" fence. Right tilt to 45, 16". I'm in Maine, I'm open to offers. Around 1000lbs of pure old iron I bought it from a cabinet shop in Mass where it was off to the side when I went to buy a Crescent p24 planer. I couldn't pass it up but I can't find a reasonable way to run 550v Three phase, which is what it needs. Not much info on these old beasts on the interweb or these sites. |
|
|
Seller assumes all responsibility for this listing.
|
Seller assumes all responsibility for this listing.
|
|
|