|
|
Seller assumes all responsibility for this listing.
This is a hydraulic cut off & trenching saw. Serial # Cj4 4060. It is 3 phase 230/460 volt, 5 HP. the footprint is 36" x 115" deep and 62" high, with the fence and rolling table it is 202"wide. Weighs well over 1000lb. The feed of cut can be set for project as needed, a foot peddle or hand pull begins the feed. The Saw was in operating condition when taken out of service, and has been stored since without activity. We can deliver at extra charge within a 200 mile radius. We will load on to your truck, or trailer free of charge. If you want to see it in operation give us advanced notice and we will get it hooked up to 3 phase and allow you a test run before purchase. We do not have any paper work with the machine. |
|
|
Seller assumes all responsibility for this listing.
|
Seller assumes all responsibility for this listing.
|
|
|