|
|
|
Seller assumes all responsibility for this listing.
I bought this at auction several years ago and never got around to getting it up and running. The motor is 3ph 220v 1/2hp, 4 speed 600 to 3600 rpm and integral to the headstock. I did get as far as replacing the two spindle bearings.
The bed (60") has scrape/scratch marks over its length, other than where the headstock has been sitting - I'm not sure what they were trying to do.
I have all the hardware to put this back together again. To make this beautiful will be a project, but I'm thinking just putting it back together as is will yield a working lathe.
$250 or best offer, and I can help load. |
|
|
|
Seller assumes all responsibility for this listing.
|
|
Seller assumes all responsibility for this listing.
|
|
|